How to assign devices with VT-d in KVM
Assigning device to guest
1. Modifying kernel config:
- make menuconfig
- set "Bus options (PCI etc.)" -> "Support for DMA Remapping Devices" to "*"
- set "Bus options (PCI etc.)" -> "Enable DMA Remapping Devices" to "*"
- set "Bus options (PCI etc.)" -> "PCI Stub driver" to "*"
- optional setting:
set "Bus options (PCI etc.)" -> "Support for Interrupt Remapping" to "*"
2. build kernel:
- make modules_install
- make install
3. reboot and verify that your system has IOMMU support
- dmesg | grep -e DMAR -e IOMMU
... DMAR:DRHD base: 0x000000feb03000 flags: 0x0 IOMMU feb03000: ver 1:0 cap c9008020e30260 ecap 1000 ...
NOTE: If you still get an error "No IOMMU found." Check dmesg for errors suggesting your BIOS is broken.
4. unbind device from host kernel driver (example PCI device 01:00.0)
- lspci -n
- locate the entry for device 01:00.0 and note down the vendor & device ID 8086:10b9
... 01:00.0 0200: 8086:10b9 (rev 06) ...
- echo "8086 10b9" > /sys/bus/pci/drivers/pci-stub/new_id
- echo 0000:01:00.0 > /sys/bus/pci/devices/0000:01:00.0/driver/unbind
- echo 0000:01:00.0 > /sys/bus/pci/drivers/pci-stub/bind
5. load KVM modules:
- modprobe kvm
- modprobe kvm-intel
6. assign device:
- /usr/local/bin/qemu-system-x86_64 -m 512 -boot c -net none -hda /root/ia32e_rhel5u1.img -pcidevice host=01:00.0
VT-d device hotplug
KVM also supports hotplug devices with VT-d to guest. In guest command interface (you can press Ctrl+Alt+2 to enter it), you can use following command to hot add/remove devices to/from guest:
- hot add:
pci_add pci_addr=auto host host=01:00.0
- hot remove (e.g bdf is 00:06.0 in guest):
- VT-d spec specifies that all conventional PCI devices behind a PCIe-to PCI/PCI-X bridge or conventional PCI bridge can only be collectively assigned to the same guest. PCIe devices do not have this restriction.
- If the device doesn't support MSI, and it shares IRQ with other devices, then it cannot be assigned due to host irq sharing for assigned devices is not supported. You will get warning message when you assign it. Notice this also apply to the devices which only support MSI-X.